Inlet Guard 4.75″ F-1X / F-3D AF006A-112 By ProCharger

Let’s face it—your ProCharger is doing God’s work, gulping down enough air to inflate a parade balloon in two seconds flat. But that kind of power comes with responsibility… like keeping pebbles, critters, and the occasional rogue zip tie out of your impeller. That’s where the 4-3/4″ Inlet Diameter ProCharger Inlet Guard saves the day.

Think of it as a goalie for your boost system—letting all the clean, glorious airflow through while blocking anything that shouldn’t be there (like that bee that ruined your last test drive). It’s built tough, fits like a glove, and doesn’t choke off performance like your friend’s questionable tuning job.

This guard is made specifically for ProChargers with a 4.75-inch inlet, offering snug, secure protection without needing to reinvent the wheel. No welding, no stress, no need to sacrifice a weekend—you can bolt this baby on with basic tools and be track-ready before your coffee gets cold.

Best part? It doesn’t mess with your flow. Your horsepower stays happy, your impeller stays intact, and your wallet stays unpunched by unexpected repair bills. It’s a small investment to keep your boost dreams alive and drama-free.

So whether you’re carving corners, roasting tires, or just trying to one-up your buddy at the next car meet, protect your ProCharger with this inlet guard. Because the only thing that should go into your blower is air—not surprises.